We use cookies to make your experience better.
To comply with the new e-Privacy directive, you agree to the privacy policy and our use of cookies.
Visonic SMD-426 PG2 Wireless Smoke Detector New spare
SKU
BJ240222-043 N11-1C 对面 XYF
$19.90
In stock
Only 101 left
BJ240222-043 N11-1C 对面 XYF
- Buy 5 for $19.00 each and save 5%
- Buy 10 for $18.00 each and save 10%
- Buy 50 for $17.00 each and save 15%
Visonic SMD-426 PG2 Wireless Smoke Detector New spare is available to buy in increments of 1
Categories: Industy & Technologies, Home, Garden, Kitchen
new spare
You may need a new Battery: 3V CR123A
Made in Taiwan.
Item location: China.
Welcome wholesale.
Scan WhatsApp QR code, Contact for more product information
You may need a new Battery: 3V CR123A
Made in Taiwan.
Item location: China.
Welcome wholesale.
Scan WhatsApp QR code, Contact for more product information
SMD-426 PG2 (photoelectric smoke detector) is an automatic fire detector with integral audible signal for open area protection, designed to sense smoke (not flame) and fitted with a PowerG type transceiver.
SMD-426 PG2 provides early warning of developing fire by sounding an alarm with its built-in alarm horn, and by transmitting a coded alarm signal to a PowerG receiver or to a compatible wireless alarm control panel.
It must be borne in mind, though that effective pre-warning of fire accidents is only possible if the detector is located, installed and maintained as described here.
In alarm condition, the buzzer sound can be stopped for 12 minutes by pressing the
TEST/MUTE switch. It will not restore the alarm condition, but will temporarily silence the
buzzer while you correct the condition. After 12 minutes, the detector restarts the alarm
buzzer sound.
Note: The TEST/MUTE switch functions as TEST switch (in normal operation) or as MUTE switch (in alarm condition).
The detector can also operate as a siren to indicate a fire alarm in other areas covered by
the alarm system, or to indicate burglar alarm events, as configured through the control panel (see the PowerMaster Installer Guide).
The tamper switch actuator (Figures 9a and 9b) is pressed against the bracket when the unit is attached to the bracket. Removal of the unit from the bracket causes the switch contacts to open, creating a tamper event, which is reported by the transceiver to the alarm system control panel.
Note: When the tamper switch is opened the detector becomes not ready for operatio
| SKU | BJ240222-043 N11-1C 对面 XYF |
|---|
